4.6 Safe working load (SWL)
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Maritime Safety Committee - MSC/Circular.1175 – Guidance on Shipboard Towing and Mooring Equipment – (24 May 2005) - Annex - Shipboard Equipment, Fittings and Supporting Hull Structures Associated with Towing and Mooring - 4 Mooring fittings - 4.6 Safe working load (SWL)

4.6 Safe working load (SWL)

  4.6.1 The SWL should not exceed 80% of the design load given in 4.3.

  4.6.2 The SWL of each shipboard fitting should be marked (by weld bead or equivalent) on the deck fittings used for mooring.

  4.6.3 The above provisions on SWL apply for a single post basis (no more than one turn of one line).

  4.6.4 The towing and mooring arrangements plan described in section 5 should define the method of use of mooring lines.

Parent topic: 4 Mooring fittings
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.