6.1 General
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Assembly - IMO Resolution A.800(19) – Revised Guidelines for Approval of Sprinkler Systems Equivalent to that Referred to in SOLAS Regulation II-2/12 – (Adopted on 23 November 1995) - Appendix 1 - Component Manufacturing Standards for Water Mist Nozzles - 6 Water Mist Nozzle Marking - 6.1 General

6.1 General

 Each nozzle complying with the requirements of this standard should be permanently marked as follows:

  • .1 trademark or manufacturer's name;

  • .2 model identification;

  • .3 manufacturer's factory identification. This is only required if the manufacturer has more than one nozzle manufacturing facility;

  • .4 nominal year of manufacturefootnote (automatic nozzles only);

  • .5 nominal release temperaturefootnote (automatic nozzles only); and

  • .6 K-factor. This is only required if a given model nozzle is available with more than 1 orifice size.

 In countries where colour-coding of yoke arms of glass bulb nozzles is required, the color code for fusible element nozzles should be used.

Parent topic: 6 Water Mist Nozzle Marking
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.