5.12.5 Calculation of the specific emissions
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - NOx Technical Code - Technical Code on Control of Emission of Nitrous Oxides from Marine Diesel Engines - Chapter 5 - Procedures for NOx emission measurements on a test bed - 5.12 Calculation of the gaseous emissions - 5.12.5 Calculation of the specific emissions

5.12.5 Calculation of the specific emissions

  5.12.5.1 The emission shall be calculated for all individual components in the following way:

(18)
where:
P i = P M, i + P AUX, i

  5.12.5.2 The weighting factors and the number of modes (n) used in the above calculation are according to the provisions of 3.2.

  5.12.5.3 The resulting average weighted NOx emission value for the engine as determined by formula (18) shall then be compared to figure 1 in 3.1 to determine if the engine is in compliance with regulation 13 of Annex VI.

Parent topic: 5.12 Calculation of the gaseous emissions
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.