Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 1 General Hull Requirements - Chapter 5 Hull Girder Strength - Appendix 2 Hull Girder Ultimate Capacity - Symbols
Symbols
For symbols not defined in this article, refer to Ch 1, Sec 4.
Iy-n50 : Moment of inertia, in m4, of the hull transverse section around its horizontal neutral axis, to be calculated according to Ch 5, Sec 1.
ZB-n50, ZD-n50 : Section moduli, in m3, at bottom and deck, respectively, defined in Ch 5, Sec 1.
ReHs : Minimum yield stress, in N/mm2, of the material of the considered stiffener.
ReHp : Minimum yield stress, in N/mm2, of the material of the considered plate.
As-n50 : Net sectional area, in cm2, of stiffener, without attached plating.
Ap-n50 : Net sectional area, in cm2, of attached plating.
zi : z coordinate, in m, of centre of gravity of the ith element.
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |