Section 10.2.4.9 Material of oil fuel pipe valves
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Maritime Safety Committee - MSC/Circular.1102 – Interpretations of the 2000 HSC Code and SOLAS Chapter X – (15 September 2003) - Annex 1 - Interpretations of Provisions of the 2000 HSC Code - Section 10.2.4.9 Material of oil fuel pipe valves

Section 10.2.4.9 Material of oil fuel pipe valves

 For valves fitted to oil fuel tanks and which are under static pressure-head, steel or modular cast iron may be accepted. However, ordinary cast iron valves may be used in piping systems where the design pressure is lower than 0.7 N/mm2 and the design temperature is below 60°C.

Parent topic: Annex 1 - Interpretations of Provisions of the 2000 HSC Code
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.