2 Physical Properties

Clasification Society 2024 - Version 9.40

Statutory Documents - IMO Publications and Documents - Guidelines - Guidelines for the Provisional Assessment of Liquids Transported in BulkMEPC/Circular.265 - Annex 8 Format for assessment of liquid chemicals - 2 Physical Properties

2 Physical Properties

2 PHYSICAL PROPERTIES
Note:	If the material is to be carried at other than ambient temperature. state the proposed carriage temperature: °C; and where possible supply physical data below at this temperature as well as at ambient.
2.1	Melting point or range:	°C
2.2	Boiling point or range:	°C
2.3	Relative density (specific gravity)
	at 20°C:
	at 37.8°C:
	at carriage temperature (if different)
2.4	Solubility in water:
	mg/100 ml at	20°
2.5	Vapour pressure, kPa
	at 20°C:
	at 37.8°C:
	at 45°C:
	at carriage temperature (if different)
2.6	Vapour density:
2.7	Dynamic viscosity
	at 20°C:	Pa s
	at carriage temperature (if different)	Pa s
2.8	Colour:
2.9	Odour and odour threshold (ppm):
2.10	Impurities likely to be present (with concentrations):
2.11	Coefficient of cubical expansion:
2.12	Electrical conductivity:
2.13	Other relevant physical data:

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.