5.12.4 Calculation of the emission mass flow rates
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - NOx Technical Code - Technical Code on Control of Emission of Nitrous Oxides from Marine Diesel Engines - Chapter 5 - Procedures for NOx emission measurements on a test bed - 5.12 Calculation of the gaseous emissions - 5.12.4 Calculation of the emission mass flow rates

5.12.4 Calculation of the emission mass flow rates

  5.12.4.1 The emission mass flow rates for each mode shall be calculated as follows (for the raw exhaust gas):

Gassmass = u·conc·GEXHW (15)

or

Gassmass = v·conc·VEXHW (16)

or

Gassmass = w·conc·VEXHW (17)

  5.12.4.2 The coefficients u-wet, v-dry and w-wet shall be used as specified in table 5.

Table 5 Coefficients u, v, w

Gas u v w conc
NOx 0.001587 0.002053 0.002053 ppm
CO 0.000966 0.00125 0.00125 ppm
HC 0.000479 - 0.000619 ppm
CO2 15.19 19.64 19.64 percent
O2 11.05 14.29 14.29 percent

Note The coefficients for u given in table 5 are correct values for an exhaust density of 1.293 only; for exhaust density ≠ 1.293, u = w/density.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.