The lining should be positioned alongside a structural core
constructed in accordance with 2.1.1.
The design of the lining should be such that it facilitates its assembly
with the limited access provided by the proximity of the structural
core, i.e. it should be mounted with the structural core in place.
During a test on an "A" class bulkhead which utilizes membrane
protection along its exposed side, e.g. a "B" class lining, it is
possible also to evaluate the performance of the lining with a view
to classification providing that the necessary thermocouples are attached
to the lining and providing that the necessary integrity measurements
are made.
The specimen should be constructed such that at least one
of the panels is of full width and this, or these, should be positioned
such that both its/their longitudinal edges are jointed to an adjacent
panel and are not secured to the restraint frame.
If the lining may incorporate electrical fittings, e.g.
light fittings and/or ventilation units, it is necessary that initially
a test is performed on a specimen of the lining itself, without the
incorporation of these units, to establish the basic performance.
A separate test(s) may be performed on a specimen(s) with the units
incorporated to ascertain their influence on the performance of the
lining.