Chapter 2.4 - Technical file and on-board NOx verification procedures
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Marine Environment Protection Committee - MEPC/Circular.473 – Approved Unified Interpretations to MARPOL Annex VI and the NOx Technical Code – (29 July 2005) - Annex - Unified Interpretations to MARPOL Annex VI And the NOx Technical Code - Technical Code on Control of Emission of Nitrogen Oxides from Marine Diesel Engines (NOx Technical Code) - Chapter 2.4 - Technical file and on-board NOx verification procedures

Chapter 2.4 - Technical file and on-board NOx verification procedures

Parent topic: Technical Code on Control of Emission of Nitrogen Oxides from Marine Diesel Engines (NOx Technical Code)

Chapter 2.4.1.1

Chapter 2.4.1.1 reads as follows:

 To enable an Administration to perform the engine surveys described in 2.1, the technical file required by 2.3.6 shall, at a minimum, contain the identification of those components, settings and operating values of the engine which influences its NOx emissions.

Interpretation:

 This section should be interpreted as follows:

Where a NOx reducing device or system is fitted in order to achieve compliance with regulation 13 (in accordance with paragraph 2.2.5), these should be identified in the Technical File.

Chapter 2.4.4.3

Chapter 2.4.4.3 reads as follows:

 On-board NOx verification procedures shall be determined by using the direct measurement and monitoring method in accordance with 2.3.4, 2.3.5, 2.3.7, 2.3.8, 2.3.11, and 5.5.

Interpretation:

 For application of this section it should be interpreted that the on-board NOx verification procedures have been approved by the Administration taking into account resolution MEPC.103(49) the "Guidelines for On-board NOx Verification Procedure - Direct Measurement and Monitoring Method".

Chapter 2.4.5

Chapter 2.4.5 reads as follows:

 When a NOx monitoring and recording device is specified as on-board NOx verification procedures, such device shall be approved by the Administration based on guidelines to be developed by the Organization. These guidelines shall include, but are not limited to, the following items:

  • .1 a definition of continuous NOx monitoring, taking into account both steady-state and transitional operations of the engine;

  • .2 data recording, processing and retention;

  • .3 a specification for the equipment to ensure that its reliability is maintained during service;

  • .4 a specification for environmental testing of the device;

  • .5 a specification for the testing of the equipment to demonstrate that it has a suitable accuracy, repeatability and cross sensitivity compared with the applicable sections of this Code; and

  • .6 the form of the approval certificate to be issued by the Administration.

Interpretation:

 For application of this section it should be interpreted that resolution MEPC.103(49) "Guidelines for On-board NOx Verification Procedure - Direct Measurement and Monitoring Method" defines the guidelines as developed by the Organization.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.