4.7.6 Lifeboat fittings
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - LSA Code - International Life-Saving Appliance Code – Resolution MSC.48(66) - Chapter IV - Survival Craft - 4.7 Free-fall lifeboats - 4.7.6 Lifeboat fittings

4.7.6 Lifeboat fittings

 Each free-fall lifeboat shall be fitted with a release system which shall:

  • .1 have two independent activation systems for the release mechanisms which may only be operated from inside the lifeboat and be marked in a colour that contrasts with its surroundings;

  • .2 be so arranged as to release the boat under any condition of loading from no load up to at least 200% of the normal load caused by the fully equipped lifeboat when loaded with the number of persons for which it is to be approved;

  • .3 be adequately protected against accidental or premature use;

  • .4 be designed to test the release system without launching the lifeboat; and

  • .5 be designed with a factor of safety of 6 based on the ultimate strength of the materials used.

Parent topic: 4.7 Free-fall lifeboats
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.