Section 6.1.3 Explanation of 'design loads'
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Maritime Safety Committee - MSC/Circular.1102 – Interpretations of the 2000 HSC Code and SOLAS Chapter X – (15 September 2003) - Annex 1 - Interpretations of Provisions of the 2000 HSC Code - Section 6.1.3 Explanation of 'design loads'

Section 6.1.3 Explanation of 'design loads'

 The intent of 6.1.3 is that under any operating load up to the breaking strength of the anchor cable or mooring lines, the loads on the bitts, bollards, etc. will not result in damage to the hull structure that will impair its watertight integrity. A strength margin of at least 20% above the minimum specified breaking strength of the relevant cable or warp should be allowed.

Parent topic: Annex 1 - Interpretations of Provisions of the 2000 HSC Code
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.