Section 2 Fabrication of classed lifting appliances
Clasification Society 2024 - Version 9.40
Clasifications Register Rules and Regulations - Code for Lifting Appliances in a Marine Environment, July 2022 - Chapter 11 Materials and Fabrication - Section 2 Fabrication of classed lifting appliances

Section 2 Fabrication of classed lifting appliances

Parent topic: Chapter 11 Materials and Fabrication

2.1 General

2.1.1 The fabrication and inspection of lifting appliances subject to classification are to comply with the Rules for the Manufacture, Testing and Certification of Materials, July 2022 and the appropriate Sections of this Code.

2.1.2 The requirements in Ch 11, 1.1 Scope, Ch 11, 1.2 General material requirements and Ch 11, 1.3 General requirements for fabrication apply to classed lifting appliances.

2.1.3 Non-Destructive Examination is to be to the satisfaction of the surveyor and in accordance with the requirements of Ch 1, 5 Non-destructive examination in the Rules for the Manufacture, Testing and Certification of Materials and the minimum requirements given in Ch 12, 3.2 Initial Survey of new installations 3.2.4.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.