Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 1 General Hull Requirements - Chapter 10 Other Structures - Section 1 Fore Part - Symbols
Symbols
For symbols not defined in this section, refer to Ch 1, Sec 4.
αp : Correction factor for the panel aspect ratio to be taken as:
but not to be taken greater than 1.0.
fbdg : Bending moment factor taken as:
ns : End fixation factor taken as:
- ns = 0 for both ends with low end fixity (simply supported).
- ns = 1 for one end fixed and one end simply supported.
- ns = 2 for continuous members or members with bracketed fitted at both ends
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |