Regulation 6 - Calculation of Volumes
Clasification Society 2023 - Version 9.38
Statutory Documents - IMO Publications and Documents - International Conventions - Tonnage - International Convention on Tonnage Measurement of Ships, 1969 - Annex I - Regulations for Determining Gross and Net Tonnages of Ships - Regulation 6 - Calculation of Volumes

Regulation 6 - Calculation of Volumes

  (1) All volumes included in the calculation of gross and net tonnages shall be measured, irrespective of the fitting of insulation or the like, to the inner side of the shell or structural boundary plating in ships constructed of metal, and to the outer surface of the shell or to the inner side of structural boundary surfaces in ships constructed of any other material.

  (2) Volumes of appendages shall be included in the total volume.

  (3) Volumes of spaces open to the sea may be excluded from the total volume.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.