2 Definitions
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.149(55) - Guidelines for Ballast Water Exchange Design and Construction Standards (G11) - (Adopted on 13 October 2006) - Annex - Guidelines for Ballast Water Exchange Design and Construction Standards (G11) - 2 Definitions

2 Definitions

  2.1 For the purposes of these Guidelines, the definitions in the Convention apply and:

  • .1 "Ballast Water Tank" – means any tank, hold or space used for the carriage of ballast water as defined in Article 1 of the Convention.

  • .2 "Sequential Method" – means a process by which a ballast tank intended for the carriage of ballast water is first emptied and then re-filled with replacement ballast water to achieve at least a 95 per cent volumetric exchange.

  • .3 "Flow-through Method" – means a process by which the replacement ballast water is pumped into a ballast tank intended for the carriage of ballast water, allowing water to flow through overflow or other arrangements.

  • .4 "Dilution Method" – means a process by which replacement ballast water is filled through the top of the ballast tank intended for the carriage of ballast water with simultaneous discharge from the bottom at the same flow rate and maintaining a constant level in the tank throughout the ballast exchange system.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.