Annex 2 Requirements for the Thickness Measurements at Renewal Surveys
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Assembly - IMO Resolution A.744(18) Guidelines on the Enhanced Programme of Inspections During Surveys for Bulk Carriers and Oil Tankers (Adopted on 4 November 1993) - Annex A - Guidelines on the Enhanced Programme of Inspections During Surveys for Bulk Carriers - Part B Guidelines on the Enhanced Programme of Inspections During Surveys of Bulk Carriers Having Double-Side Skin Construction - Annex 2 Requirements for the Thickness Measurements at Renewal Surveys

Annex 2 Requirements for the Thickness Measurements at Renewal Surveys

AGE ≤ 5 years 5 < AGE ≤ 10 years 10 < AGE ≤ 15 years AGE > 15 years
1 2 3 4
1 Suspect areas 1 Suspect areas 1 Suspect areas 1 Suspect areas
2 Within the cargo length area: 2 Within the cargo length area: 2 Within the cargo length area:
.1 two transverse sections of deck plating outside line of cargo hatch openings .1 each deck plate outside line of cargo hatch openings .1 each deck plate outside line of cargo hatch openings
.3 Measurement, for general assessment and recording of corrosion pattern, of those structural members subject to close-up survey according to annex 1 .2 two transverse sections, one of which should be in the amidship area, outside line of cargo hatch openings .2 three transverse sections, one of which should be in the amidship area, outside line of cargo hatch openings
.4 All cargo holds hatch covers and coamings (plating and stiffeners). .3 Measurement, for general assessment and recording of corrosion pattern, of those structural members subject to close-up survey according to annex 1. .3 each bottom plate
.5 All deck plating inside line of openings between cargo hold hatches .4 All cargo hold hatch covers and coamings (plating and stiffeners). .3 Points 3 to 7 referred to in column 3
.6 Wind and water strakes in way of transverse sections considered under point 2 above. .5 All deck plating inside line of openings between cargo hold hatches.  
  .6 All wind and water strakes within the cargo length area.  
  .7 Selected wind and water strakes outside the cargo length area.  
  .8 As required by annex 12 for ships subject to compliance with regulation XII/6.2 of the Convention.  

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.