6 Procedures
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - HSC 2000 Code - International Code of Safety for High-Speed Craft, 2000 – Resolution MSC.97(73) - Annex 4 - Procedures for failure mode and effects analysis - 6 Procedures

6 Procedures

 The following steps are necessary to perform FMEA:

  • .1 to define the system to be analysed;

  • .2 to illustrate the interrelationships of functional elements of the system by means of block diagrams;

  • .3 to identify all potential failure modes and their causes;

  • .4 to evaluate the effects on the system of each failure mode;

  • .5 to identify failure detection methods;

  • .6 to identify corrective measures for failure modes;

  • .7 to assess the probability of failures causing hazardous or catastrophic effects, where applicable;

  • .8 to document the analysis;

  • .9 to develop a test programme;

  • .10 to prepare FMEA report.

Parent topic: Annex 4 - Procedures for failure mode and effects analysis
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.