Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 1 General Hull Requirements - Chapter 8 Buckling - Section 2 Slenderness Requirements - Symbols
Symbols
For symbols not defined in this section, refer to Ch 1, Sec 4.
bf-out : Maximum distance, in mm, from mid thickness of the web to the flange edge, as shown in Figure 1.
hw : Depth of stiffener web, in mm, as shown in Figure 1.
: Effective length of edge of bracket, in mm, as defined in Table 3.
seff : Effective width of attached plate of stiffener, in
mm, taken equal to:
- seff = 0.8 s
tf : Net flange thickness, in mm.
tp : Net thickness of plate, in mm.
tw : Net web thickness, in mm.
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |