Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 1 General Hull Requirements - Chapter 12 Construction - Section 3 Design of Weld Joints - Symbols
Symbols
Aweld : Effective fillet weld area, in cm2.
f : Root face, in mm.
fweld : Weld factor.
fyd : Correction factor taking into account the yield strength of the weld deposit as defined in [2.5.2].
ℓdep : Total length of deposit of weld metal, in mm.
ℓleg : Leg length of continuous, lapped or intermittent fillet weld, in mm.
ℓweld : Length of the welded connection in mm.
ReH_weld : Minimum yield stress of weld deposit, in N/mm2.
tas-built : As-built thickness of the member being joined, in mm.
tgap : Allowance for fillet weld gap, is to be taken equal to 2.0 mm.
tthroat : Throat thickness of fillet weld in mm, as defined in [2.5.3].
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |