10.2 CAS Final Report to the Administration
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.94(46) - Condition Assessment Scheme - (adopted on 27 April 2001) - Annex - Condition Assessment Scheme - 10 CAS Final Report to the Administration - 10.2 CAS Final Report to the Administration

10.2 CAS Final Report to the Administration

  10.2.1 The RO shall prepare a CAS Final Report to the Administration upon completion of the CAS survey and following the review of the CAS survey reports by the RO’s Headquarters, as specified in paragraph 10.1.1.

  10.2.2 The CAS Final Report shall be submitted by the RO to the Administration without delay and:

  • .1 in the case of the CAS survey in accordance with regulation 20.6 or 21.6.1, not later than 3 months after the completion of the CAS survey; or

  • .2 in the case of the CAS survey in accordance with regulation 20.7, not later than 3 months after the completion of the CAS survey, or 2 months prior to the date the ship is required to be issued with a Statement of Compliance, whichever occurs earlier.

  10.2.3 The CAS Final Report shall, at least, include:

  • .1 the following general particulars:

    Ship's name

    IMO number

    Flag State

    Port of registry

    Gross tonnage

    Deadweight (tonnes)

    Summer load line draught

    Date of delivery

    Category of ship

    Date for compliance with regulation 19

    Company

    Report identification reference

  • .2 a summary as to where, when, by whom and how the CAS survey was carried out;

  • .3 a statement identifying all survey documentation, including the Survey Plan;

  • .4 a statement as to the condition of the corrosion prevention system(s) applied to the spaces;

  • .5 a statement identifying all thickness measurement reports;

  • .6 a summary of the findings of the overall surveys;

  • .7 a summary of the findings of the close-up surveys;

  • .8 a summary of the hull repairs carried out;

  • .9 an identification, together with the location, the extent and the condition, of all areas with substantial corrosion;

  • .10 a summary of the results of the evaluation of the thickness measurements, including identification of the areas and sections where thickness measurements were carried out;

  • .11 an evaluation of the structural strength of the vessel and an assessment of compliance with the acceptance criteria set out in section 8;

  • .12 a statement as to whether all the applicable requirements of the CAS have been met;

  • .13 a recommendation to the Administration as to whether the ship should be allowed to continue operating until the date envisaged in regulation 20 for compliance with the requirements of regulation 19 or for the period of validity of the CAS, if earlier; and

  • .14 conclusions.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.