Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 2 Ship Types - Chapter 2 Oil Tankers - Section 3 Hull Local Scantling - Symbols
Symbols
For symbols not defined in this section, refer to Pt 1, Ch 1, Sec 4.
S : Primary supporting member spacing as defined in Pt 1, Ch 3, Sec 7, [1.2.2], in m.
Ct-pr
: Permissible shear stress coefficient for primary supporting members taken equal
to:
- Ct-pr = 0.70 for AC-S.
- Ct-pr = 0.85 for AC-SD.
Cs-pr
: Permissible bending stress coefficient for primary supporting members taken equal
to:
- Cs-pr = 0.70 for AC-S.
- Cs-pr = 0.85 for AC-SD.
scg : Half pitch length of corrugation, in mm. See Figure 4.
ℓcg : Length of corrugation, in m, which is defined as the distance between the lower stool and the upper stool. Where no lower or upper stool is fitted, ℓcg is to be measured to lower or upper end as shown in Figure 4.
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |