3.4 Shipboard fittings
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Maritime Safety Committee - MSC/Circular.1175 – Guidance on Shipboard Towing and Mooring Equipment – (24 May 2005) - Annex - Shipboard Equipment, Fittings and Supporting Hull Structures Associated with Towing and Mooring - 3 Towing fittings - 3.4 Shipboard fittings

3.4 Shipboard fittings

 The selection of shipboard fittings should be made by the shipyard in accordance with industry standards (e.g. ISO 3913:1977 Shipbuilding-Welded steel bollards) accepted by the Administration. When the shipboard fitting is not selected from an accepted industry standard, the design load used to assess its strength and its attachment to the ship should be in accordance with 3.3 above.

Parent topic: 3 Towing fittings
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.