7 Retained sample handling
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.182(59) – 2009 Guidelines for the Sampling of Fuel Oil for Determination of Compliance with the Revised MARPOL Annex VI – (Adopted on 17 July 2009) - Annex – 2009 Guidelines for the Sampling of Fuel Oil for Determination of Compliance with the Revised MARPOL Annex VI - 7 Retained sample handling

7 Retained sample handling

  7.1 The retained sample container should be clean and dry.

  7.2 Immediately prior to filling the retained sample container, the primary sample quantity should be thoroughly agitated to ensure that it is homogeneous.

  7.3 The retained sample should be of sufficient quantity to perform the tests required but should not be less than 400 ml. The container should be filled to 90% ± 5% capacity and sealed.

Parent topic: Annex – 2009 Guidelines for the Sampling of Fuel Oil for Determination of Compliance with the Revised MARPOL Annex VI
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.