Statutory Documents - MCA Publications - LY2 - The Large Commercial Yacht Code - Annex 6 Technical Standard for Helicopter Landing Areas - Section 7 - Helicopter Hangar Facilities - 1.0 General
1.0 General
1.1 Helicopter hangar arrangements on board should be in accordance with requirements for helicopter refuelling and hangar facilities contained within SOLAS II-2. In addition, the requirements outlined in this section of Annex 6 of the Code should be complied with in full. The requirements in this section are based upon the use of helicopters run on Jet A1 fuel. When developing hangar arrangements, consideration should be given to the type of fuel on which the helicopter to be stowed is run.
1.2 The following plans and particulars are to be submitted to the Classification Society and Administration for approval:
-
.1 Hangar general arrangement and structure;
-
.2 Helicopter lift, hoist, and movement arrangements (if appropriate);
-
.3 Structural fire protection;
-
.4 Fire detection and extinguishing arrangements;
-
.5 ventilation arrangements.
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |