7 Pumping, piping and discharge arrangements (regulation 18)
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Marine Environment Protection Committee - MEPC/Circular.406 – Guidelines for Application of MARPOL Annex I Requirements to FPSOs and FSUs – (10 November 2003)1 - Annex - Guidelines for Application of MARPOL Annex I Requirements to FPSOs And FSUs - Annex 2 - Record of Construction and Equipment for FPSOs and FSUs - 7 Pumping, piping and discharge arrangements (regulation 18)

7 Pumping, piping and discharge arrangements (regulation 18)

7.1 The overboard discharge outlets for segregated ballast are located:
7.1.1 Above the waterline
7.1.2 Below the waterline
7.2 The overboard discharge outlets, other than the discharge manifold, for clean ballast are locatedfootnote:
7.2.1 =

Above the waterline
7.2.1 Below the waterline
7.3 The overboard discharge outlets, other than the discharge manifold, for dirty ballast water or oil-contaminated water from produced oil tank areas are located:
7.3.1 Above the waterline
7.3.2 Below the waterline in conjunction with the part flow arrangements consistent with regulation 18(6)(e)
7.3.3 Below the waterline
7.4 Discharge of oil from produced oil pumps and oil lines (regulation 18(4) and (5)):
7.4.1 Means to drain all produced oil pumps and oil lines at the completion of produced oil discharge:
.1 drainings capable of being discharged to a produced oil tank or slop tank
.2 for discharge a special small-diameter line is provided
Parent topic: Annex 2 - Record of Construction and Equipment for FPSOs and FSUs
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.