CHAPTER IV SURVIVAL CRAFT
4.4 General requirements for lifeboats
1 Paragraph 4.4.8.1 is replaced by the following:
- ".1 except for a lifeboat equipped with two independent
propulsion systems, where the arrangement consists of two separate engines,
shaft lines, fuel tanks, piping systems and any other associated
ancillaries, and for a free fall lifeboat, sufficient buoyant oars to make
headway in calm seas. Thole pins, crutches or equivalent arrangements shall
be provided for each oar provided. Thole pins or crutches shall be attached
to the boat by lanyards or chains;"
CHAPTER VI LAUNCHING AND EMBARKATION APPLIANCES
6.1 Launching and embarkation appliances
2 The following text is added at the end of paragraph 6.1.1.3:
"Notwithstanding the above, on cargo ships equipped with a rescue boat which is not
one of the ship's survival craft, having a mass not more than 700 kg in fully
equipped condition, with engine, but without the crew, the launching appliance of
the boat does not need to be fitted with stored mechanical power provided that:
-
.1 manual hoisting from the stowed position and turning out to the
embarkation position is possible by one person;
-
.2 the force on the crank handle does not exceed 160 N at the maximum
crank radius of 350 mm; and
-
.3 means having sufficient strength such as bowsing line are provided for
bringing the rescue boat against the ship's side and holding it
alongside so that persons can be safely embarked."