Common Structural Rules - Common Structural Rules for Bulk Carriers and Oil Tankers, January 2019 - Part 1 General Hull Requirements - Chapter 11 Superstructure, Deckhouses and Hull Outfitting - Section 4 Supporting Structure for Deck Equipment and Fittings - 1 General
1 General
1.1 Application
1.1.1
Information pertaining to the supporting structure for deck equipment and fittings, as listed in this section, is to be submitted for approval.
This section includes scantling requirements to the supporting structure and
foundations of the following pieces of equipment and fittings:
- Anchor windlasses.
- Anchoring chain stoppers.
- Mooring winches.
- Deck cranes, derricks and lifting masts.
- Bollards and bitts, fairleads, stand rollers, chocks and capstans.
1.1.2
Where deck equipment is subject to multiple load cases, such as operational loads and green sea load, the loads are be applied independently for the evaluation of strength of foundations and support structure.
1.2 Documents to be submitted
1.2.1
The documents to be submitted are indicated in Ch 1, Sec 3.
| Copyright 2020 Clasification Society, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasification Society, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasification Society'. Clasification Society Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasification Society entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. |  |