Section 1 General
Clasification Society 2024 - Version 9.40
Clasifications Register Guidance Information - Guidance Notes for the Classification of Special Service Craft – Calculation Procedures for Composite Construction, July 2013 - Chapter 2 Design procedures - Section 1 General

Section 1 General

1.1 This section outlines the Rule approach to the design of structural members to be built in FRP and provides example calculations.

1.2 The procedures contained in these Guidance Notes are for:

  1. Design of single skin hull laminates.

  2. Design of sandwich panel laminates.

  3. Design of typical stiffening members.

Parent topic: Chapter 2 Design procedures
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.