Appendix 5 - Analyser Information Templates
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Resolutions - Marine Environment Protection Committee - Resolution MEPC.340(77) - 2021 Guidelines for Exhaust Gas Cleaning Systems - (adopted on 26 November 2021) - Appendix 5 - Analyser Information Templates

Appendix 5 - Analyser Information Templates

 Under subsection 8.2 of these Guidelines certain information, as a minimum, should be included in the OMM in order to facilitate surveys and inspections.

Paragraph 8.2.4 requires that information should be given in respect of the exhaust gas and discharge water analysers used in the respective monitoring systems. In order to provide a common approach to the layout and detail which should be included, the following templates are provided and may be used in the OMM. These templates represent the minimum information which should be given. Additional information may be required by the Administration.

The use of these templates is voluntary; however, a standardized layout will assist all users of the OMM.

Exhaust gas

SO2 / CO2 measurement
Where common, so indicate
Analyser SO2 CO2
Analyser manufacturer    
Model reference    
Onboard identification reference    
Arrangement In situ/extractive In situ/extractive
Probe location    
Probe description (i.e. probe length, single/multiple hole/heated filter/heated pump) (i.e. probe length, single/ multiple hole/heated filter/ heated pump)
Maximum measurement range ppm %
Used measurement range(s) ppm %
Zero gas specification    
Span gas specification    
Details of: service, maintenance, calibration schedules Task/interval Task/interval
Additional information    
Extractive systems only:    
Application Single or multiple exhaust ducts (if multiple – state which ducts covered and sampling sequence, residence and purge times) Single or multiple exhaust ducts (if multiple – state which ducts covered and sampling sequence, residence and purge times)
Sample line heated (if yes – maintained temperature °C) Yes/No Yes/No
Sample line details Length, inner diameter Length, inner diameter
Cooler/dryer:

Manufacturer

Model reference

    
Additional information    

Water monitoring

pH/PAH/Turbidityfootnote  
Application Seawater inlet/discharge waterfootnote
Analyser manufacturer  
Model reference  
Onboard identification reference  
Arrangement In situ/bypassfootnote
   
Position of sensor  
Maximum measurement range/units  
Used measurement range(s)/units  
Calibration fluid(s) – specification/ concentration/units  
Details of:

service,

maintenance,

calibration schedules

 Task/interval
Additional information

 
Parent topic: Resolution MEPC.340(77) - 2021 Guidelines for Exhaust Gas Cleaning Systems - (adopted on 26 November 2021)
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.