4.4 Steam pipe systems
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - International Codes - 1979 MODU Code – Code for the Construction and Equipment of Mobile Offshore Drilling Units – Resolution A.414(XI) - Chapter 4 – Machinery Installations for all Types of Units - 4.4 Steam pipe systems

4.4 Steam pipe systems

  4.4.1 Every steam pipe and every fitting connected thereto through which steam may pass should be so designed, constructed and installed as to withstand the maximum working stresses to which it may be subjected.

  4.4.2 Efficient means should be provided for draining every steam pipe where otherwise dangerous water hammer action might occur.

  4.4.3 If a steam pipe or fitting may receive steam from any source at a higher pressure than that for which it is designed a suitable reducing valve, relief valve and pressure gauge should be fitted.

Parent topic: Chapter 4 – Machinery Installations for all Types of Units
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.