Section 11 Plate heat exchangers
Clasification Society 2024 - Version 9.40
Clasifications Register Rules and Regulations - Rules and Regulations for the Classification of Naval Ships, January 2023 - Volume 2 Machinery and Engineering Systems - Part 8 Pressure Plant - Chapter 2 Other Pressure Vessels - Section 11 Plate heat exchangers

Section 11 Plate heat exchangers

Parent topic: Chapter 2 Other Pressure Vessels

11.1 General

11.1.1 Plate heat exchangers are to be classed as follows:

Class 2 where either of the following conditions apply:

  1. the maximum metal design temperature is 150°C or greater; or

  2. design pressure is 1,72 MPa or greater.

Class 3 in all other cases.

11.1.2 Where the design temperature is equal to or lower than minus 10°C, a higher class is to apply.

Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.