2.2.1 Plans
are to be of sufficient detail for plan approval purposes. For all
areas of structure listed below the submitted plans are to show all
plating thickness, stiffeners sizes and spacings, bracket arrangements
and connections. Where appropriate, the plans should clearly show
the allowance for corrosion margin or Owner's extra. Welding, constructional
arrangements and tolerances are also to be submitted and this may
be in the form of a booklet.
2.2.2 In general
all items of steel structure are to be shown except where they are
ineffective in supporting hull girder and local loads and do not impinge
on such structure.
2.2.3 Equipment
seating and supports are to be shown where they require additional
stiffening and support to be incorporated in items of hull structure.
In such cases the loading on the seating is also to be supplied. Generally
total combined equipment weights on seating less than 0,5 tonnes need
not be considered.
2.2.4 Normally
the plans for each item will be able to be contained on a few sheets.
Unit or production drawings will not be accepted.
2.2.5 Plans
and calculations are to be submitted as required in the Complementary
Rules and are to include all appropriate structure in the side hulls,
centre hull and cross deck structure.
2.2.6 The
details of the cross deck structure connections, forward and aft,
to the main and centre hulls must either be included within the required
plans or be provided as a separate plan.
2.2.7 Plans
are to be supplied to the ship as required in the Complementary Rules.