4.1 External Sensors
Clasification Society 2024 - Version 9.40
Statutory Documents - IMO Publications and Documents - Circulars - Safety of Navigation - Circular SN/Circ.227- Guidelines for the Installation of a Shipborne Automatic Identification System (AIS) – (6 January 2003)Amended by SN/Circ.245 - Annex - Guidelines for the Installation of a Shipborne Automatic Identification System (AIS) - 4 Dynamic data input - 4.1 External Sensors

4.1 External Sensors

 The AIS has interfaces (configurable as IEC 61162-1 or 61162-2) for position, heading and rate of turn (ROT) sensors. In general, sensors installed in compliance with other carriage requirements of SOLAS Chapter V should be connected to the AIS.footnote The sensor information transmitted by AIS should be the same information being used for navigation of the ship. The interfaces should be configured as given in annex 3. Interfacing problems might occur if the existing sensors found on board do not have serial (IEC 61162) outputs.

Parent topic: 4 Dynamic data input
Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.