Section 3 Materials
Clasification Society 2024 - Version 9.40
Clasifications Register Rules and Regulations - Rules and Regulations for the Classification of Special Service Craft, July 2022 - Part 12 Propulsion Devices - Chapter 1 Propellers - Section 3 Materials

Section 3 Materials

3.1 Castings for propellers

3.1.1  Castings for propellers and propeller blades are to comply with the requirements of the Rules for the Manufacture, Testing and Certification of Materials, July 2022 (hereinafter referred to as the Rules for Materials). The chemical composition and mechanical properties of steel castings are given in Ch 4, 5 Castings for propellers of the Rules for Materials and those of the copper alloys are given in Ch 9, 1 Castings for propellersof the Rules for Materials.

3.1.2 The specified minimum tensile strength of the castings is to be not less than stated in Table 1.3.1 Materials for propellers.

Table 1.3.1 Materials for propellers

Material Specified minimum tensile strength

N/mm2

G

Density

g/cm3

U

Allowable stress

N/mm2

Carbon steels 400 7,9 20,6
Low alloy steels 440 7,9 20,6
13% chromium stainless steels 540 7,7 41
Chromium - nickel austenitic stainless steel 450 7,9 41
Duplex stainless steels 590 7,8 41
Grade Cu 1
Manganese bronze
(high tensile brass)
440 8,3 39
Grade Cu 2
Ni-Manganese bronze
(high tensile brass)
440 8,3 39
Grade Cu 3
Ni-Aluminium bronze
590 7,6 56
Grade Cu 4
Mn-Aluminium bronze
630 7,5 46

3.1.3 Where propellers of carbon and low alloy steels shown in Table 1.3.1 Materials for propellers are provided with an approved method of cathodic protection, special consideration will be given to the value of U.


Copyright 2022 Clasifications Register Group Limited, International Maritime Organization, International Labour Organization or Maritime and Coastguard Agency. All rights reserved. Clasifications Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Clasifications Register'. Clasifications Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Clasifications Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.